|Part of a series on|
Below we consider a circular orbit in astrodynamics or celestial mechanics under standard assumptions. Here the centripetal force is the gravitational force, and the axis mentioned above is the line through the center of the central mass perpendicular to the plane of motion.
In this case, not only the distance, but also the speed, angular speed, potential and kinetic energy are constant. There is no periapsis or apoapsis. This orbit has no radial version.
Transverse acceleration (perpendicular to velocity) causes change in direction. If it is constant in magnitude and changing in direction with the velocity, we get a circular motion. For this centripetal acceleration we have
- is orbital velocity of orbiting body,
- is radius of the circle
- is angular speed, measured in radians per unit time.
The formula is dimensionless, describing a ratio true for all units of measure applied uniformly across the formula. If the numerical value of is measured in meters per second per second, then the numerical values for will be in meters per second, in meters, and in radians per second.
Equation of motion
The orbit equation in polar coordinates, which in general gives r in terms of θ, reduces to:
- is specific angular momentum of the orbiting body.
This is because
Angular speed and orbital period
Hence the orbital period () can be computed as::28
Compare two proportional quantities, the free-fall time (time to fall to a point mass from rest)
- (17.7% of the orbital period in a circular orbit)
and the time to fall to a point mass in a radial parabolic orbit
- (7.5% of the orbital period in a circular orbit)
The fact that the formulas only differ by a constant factor is a priori clear from dimensional analysis.
The specific orbital energy () is negative, and
Thus the virial theorem:72 applies even without taking a time-average:
- the kinetic energy of the system is equal to the absolute value of the total energy
- the potential energy of the system is equal to twice the total energy
The escape velocity from any distance is √ times the speed in a circular orbit at that distance: the kinetic energy is twice as much, hence the total energy is zero.
Delta-v to reach a circular orbit
Maneuvering into a large circular orbit, e.g. a geostationary orbit, requires a larger delta-v than an escape orbit, although the latter implies getting arbitrarily far away and having more energy than needed for the orbital speed of the circular orbit. It is also a matter of maneuvering into the orbit. See also Hohmann transfer orbit.
Orbital velocity in general relativity
In Schwarzschild metric, the orbital velocity for a circular orbit with radius is given by the following formula:
where is the Schwarzschild radius of the central body.
For the sake of convenience, the derivation will be written in units in which .
The four-velocity of a body on a circular orbit is given by:
( is constant on a circular orbit, and the coordinates can be chosen so that ). The dot above a variable denotes derivation with respect to proper time .
For a massive particle, the components of the four-velocity satisfy the following equation:
We use the geodesic equation:
The only nontrivial equation is the one for . It gives:
From this, we get:
Substituting this into the equation for a massive particle gives:
Assume we have an observer at radius , who is not moving with respect to the central body, that is, their four-velocity is proportional to the vector . The normalization condition implies that it is equal to:
The dot product of the four-velocities of the observer and the orbiting body equals the gamma factor for the orbiting body relative to the observer, hence:
This gives the velocity:
Or, in SI units:
- Lissauer, Jack J.; de Pater, Imke (2019). Fundamental Planetary Sciences : physics, chemistry, and habitability. New York, NY, USA: Cambridge University Press. p. 604. ISBN 9781108411981.