Nominal level is the operating level at which an electronic signal processing device is designed to operate. The electronic circuits that make up such equipment are limited in the maximum signal they can handle and the low-level internally generated electronic noise they add to the signal. The difference between the internal noise and the maximum level is the device's dynamic range. The nominal level is the level that these devices were designed to operate at, for best dynamic range and adequate headroom. When a signal is chained with improper gain staging through many devices, the dynamic range of the signal is reduced.
In audio, a related measurement, signal-to-noise ratio, is usually defined as the difference between the nominal level and the noise floor, leaving the headroom as the difference between nominal and maximum output. It is important to realize that the measured level is a time average, meaning that the peaks of audio signals regularly exceed the measured average level. The headroom measurement defines how far the peak levels can stray from the nominal measured level before clipping. The difference between the peaks and the average for a given signal is the crest factor.
There is some confusion over the use of the term "nominal", which is often used incorrectly to mean "average or typical". The relevant definition in this case is "as per design"; gain is applied to make the average signal level correspond to the designed, or nominal, level.
VU meters are designed to represent the perceived loudness of a passage of music, measuring in volume units. The product is designed so that the best signal quality is obtained when the meter rarely goes above nominal. The markings are often in dB instead of "VU", and the reference level is defined in the product's manual. In professional recording and sound reinforcement gear, the nominal level is 0 VU = +4 dBu. In consumer level equipment, the nominal level varies, but some standardize to 0 VU = −10 dBV. The difference between consumer and pro equipment revolves around the cost required to create larger power supplies and output higher levels.
In broadcasting equipment, this is termed the Maximum Permitted Level, which is defined by European Broadcasting Union standards. These devices use peak programme meters instead of VU meters, which gives the reading a different meaning.
"Mic level" is sometimes defined as −60 dBV, though levels from microphones vary widely.
In video systems, nominal levels are 1 VP-P for synched systems, such as baseband composite video, and 0.7 VP-P for systems without sync. Note that these levels are measured peak-to-peak, while audio levels are time averages.
- AES Pro Audio Reference definition of signal-to-noise ratio
- AES Pro Audio Reference definition of headroom
- Extron Electronics Glossary of Terms definition of nominal level
- TRV900 Technical Measurements - "The nominal baseband composite video signal has an amplitude of 1.0 Vpp."
- Video Signal Standards and Conversion Page - "The Y signal has a nominal level of 1Vpp and C signal a level of around 0.5V.", "The nominal signal level is 1Vpp on a 75 ohm terminated line."
- Nominal Level — Sweetwater glossary
- Level Headed — Nominal Level (explained) plus an SV-3700 modification